GEO_XI.I Protocols utilises your Black Edition MitoHQ EMF Meter to bring about a natural energetic state within a 30-meter diameter circle by managing geopathic stressors real-time.
There is a world in which few have taken the time to explore and that is geopathic stress. The subject being quite complex is mostly swept under the carpet even though these strings in time, water veins, and energetic grid systems play a vital part in our everyday lives. For years farmers in the know have used ground stakes for earth acupuncture, mirrors to counteract disruptive energy lines and built their homes around the grid systems so they could live in geopathic friendly environments.
Today the earth energy grid systems have been exponentially compromised by both man and non-native EMF's. (Electromagnetic Fields/Electric Magnetic Force) Studies have shown that spending extended periods of time or sleeping over geopathic stress lines and earth-ray grid systems can cause serious health issues.
The Black Edition MitoHQ Meters GEO_XI.I >XXX< Purple Protocols run from the point of time the protocols are activated on the MitoHQ Meter to the following sunrise.
Read more HERE on which geo-stressors the Purple GEO_XI.I >XXX< Protocols cover.
1/ To active the GEO_XI.I >XXX< Purple Protocols turn the sound switch to the ON position and turn on the meter.
2/ Then after the Meter cycles on with the LED lights finishing their right to left sweep, turn the sound switch to OFF and back to ON within six seconds of the LED lights powering up/boot cycle.
The GEO_XI.I >XXX< Purple Protocols are now active.
GEO_XI.I end-user must remain within 15 meters of the MitoHQ Meter for the protocols to remain in effect as the meter and you act as an anchor point for the protocols. As soon as you step back within 15 meters of the Black MitoHQ Meter, after leaving the perimeter, the protocols go back into effect without restarting the protocols. The protocols will remain in effect until sunrise.
3/ If you want to turn off the GEO_XI.I Protocols, turn back on the MitoHQ Meter followed by switching off the sound.
The meter acts as an active interface and anchor point to you the observer in the few seconds in which you set/define the perimeters/script. Everything else that takes place happens outside of the device.
The GEO_XI.IProtocols can be measured in action using a couple of L shaped rods/wire or cut back metal coat hangers. (L-Rods) Bio Geometry and Geovital measurement tools can also be used to measure the GEO_XI.I Protocols in action.
With the GEO_XI.I >XXX< Purple Protocols inactive, the rods will cross when you measure a curry line. )North East/South West diagonal lines) Activate the GEO_XI.I Protocols and measure again, the rods will remain straight. After sunrise, the curry lines will be active again.
Biomarkers can also be used to monitor the effects of harmful energy lines and earth rays crossing beds. People living in built-up areas and especially in apartments will notice the most difference.
GEO_XI.I will not cancel magnetic anomalies caused by rock formations or metal structures. To test for magnetic anomalies use your phone compass. Areas that vary more than 10 degrees off true north should be avoided.
GEO_XI.I will not neutralise or eliminate non-native EMF's or RF/Microwaves.
Custom GEO maps can also be created for farming, horticulture and security applications by request.